Parts Description - Makita CL003G Instruction Manual

NOTE: You can change the suction power before
turning on the cleaner.
NOTE: The cleaner starts the operation with the
same suction power as the last operation.

PARTS DESCRIPTION

Country specific
► Fig.6
1 250 mL dust case
(Optional accessory)
5 High performance
filter (Filter frame in
gray color) (Optional
accessory)
9 Hand strap (Country
specific)
ASSEMBLY
Always be sure that the tool is
CAUTION:
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Make sure all the attachments and
NOTICE:
components are secured in place properly before
use.
Installing and removing cleaner
attachments
After installing attachments, check
CAUTION:
if they are securely installed. If the attachments are
installed imperfectly, they may come off and cause
personal injury.
Be careful not to hit your hand on
CAUTION:
the wall etc. when removing the attachments.
When using attachment with lock
function
To install attachment, insert it to the suction inlet of the cleaner
until it clicks. Make sure that the attachment is locked.
► Fig.7: 1. Suction inlet 2. Attachment with lock func-
tion 3. Hook
2 400 mL dust case
(Optional accessory)
HEPA filter (Filter frame
6
in white color) (Optional
accessory)
- -
14 ENGLISH
Lighting up the lamp
Do not look in the light or see the
CAUTION:
source of light directly.
To turn on the lamp, push the suction power change
button. The lamp goes off in approximately 10 seconds.
While the cleaner is running, the lamp turns on.
The lamp goes out approximately 10 seconds after
stopping operation.
NOTE: When the remaining battery capacity gets low,
the lamp starts blinking. The timing, at which the lamp
starts blinking depends on the temperature at work
place and the battery cartridge conditions.
► Fig.5: 1. Suction power change button 2. ON/OFF
button 3. Lamp
Mesh filter
3
7 Sponge sheet
- -
When installing the attachment with
NOTICE:
lock function, be sure to align the release button
on the cleaner with the hook on the attachment. If
they are not aligned, the attachment will not be locked
and may come off from the cleaner.
To remove attachment, pull it off the cleaner while
pressing and holding the arms of the release button.
► Fig.8: 1. Release button 2. Arm of release button
3. Attachment with lock function 4. Suction
inlet
When using attachment without lock
function
To install attachment without lock func-
NOTICE:
tion, insert it into the suction inlet of the cleaner
by twisting it as shown in the figure. To detach
attachment, release it from the cleaner by twist-
ing it as shown in the figure. Avoid twisting the
attachment in the direction opposite to the arrow
in the figure as it may loosen the cyclone unit.
► Fig.9
4 Cyclone body
8 Cleaner body
- -