Table of Contents
Advertisement
(Note 1)
The above illustration shows an eight-pin type when it is removed from the unit.
(Note 2)
Use a screwdriver listed in the following table as a dedicated tool or equivalent (blade width: 0.4 x
2.5).
Manufacturer
Phoenix Contact Co., Ltd
● The following precautions should be observed to avoid broken or disconnected wires.
• When removing the wire's sheath, be careful not to scratch the core wire.
• Do not twist the wires to connect them.
• Do not solder the wires to connect them. The solder may break due to vibration.
• After wiring, make sure stress is not applied to the wire.
WUME-FPXHAIO-01
2.3 Wiring to the Connector
Model number
SZS 0, 4x2, 5
Production number
1205037
2-9
Advertisement
Table of Contents
