Table of Contents
Advertisement
6.2.2.
Assembly Procedure
Important notice：
When tightening the screw, use a torque driver (RFKZ0542) with specified torque described in each step.
6.2.2.1. Installation of 1st Lens Frame Unit and Adjust Screw
1. Install 1st Lens Frame Unit.
2. Insert Adjustment Screw using a nipper with a fine tip since the screw is small.
3. Tighten screw so that the screw mark meets with a horizontal straight line.
Note: Because it is necessary to return the screws to original position when assembling,
recommend to take a picture before removing it.
Horizontal Straight Line
Adjustment Screw
※ Saving Adjustment Screw position
by taking a picture
Marking
1st Lens Frame Unit
16
Advertisement
Table of Contents
