Panasonic Lumix S-R70300 Service Training Manual page 21

6.2.2.4. Installation of Zoom Ring Rubber
1. Stick new Zoom Ring Tape to Lens Unit. While pulling a Tape, stick Tape little by little with pressing out air bubble.
Caution：
a. Remove all dust from Lens Unit.
b. Avoid air or air bubble between Tape and Lens Unit. Remove all dust from Lens Unit.
c. Avoid overlap and sticking out.
d. Tape gap should be less avoid overlap and sticking out. Than 1.0mm.
Tape gap : Less than 1.0
2. After applying adhesive on Zoom Ring Tape, install the Zoom Ring Rubber.
Prepare adhesive：
Adhesive : Super X No. 8008
Amount : 4mg x 10 points
Procedure：
a. Do not let adhesive stick out of Zoom Ring.
b. Zoom Ring Rubber should not float.
Adhesive
Back side
Zoom Ring Tape
Front side
mm
Zoom Ring Rubber
19