Advertisement
Table of Contents
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Knightsbridge TNXQUADSTW
Summary of Contents for Knightsbridge TNXQUADSTW
- Page 1 INSTALLATION & MAINTENANCE MANUAL TNXQUADSTW / TNXQUADSTBK TNXONESTW / TNXONESTBK...
-
Page 2: General Instructions
These instructions should be used to aid installation of the following products: TNXQUADSTW / TNXQUADSTBK / TNXONESTW / TNXONESTBK SAFETY • This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671) and current Building Regulations. - Page 3 surface using the plugs and screws provided manufacturer of the sensors that they are compatible with LED luminaires. Ensuring correct polarity is observed, carefully wire as shown in Fig. 1 • Provide power to the required point of installation (refer to BS7671 for correct cabling methods). •...
-
Page 4: Self-Test Function
Fig. 3 • Re-attach the diffuser to the luminaire body using the four screws • Switch on and check for correct operation ensuring the green indicator LED is illuminated Fig. 3 • See below for operation of the self-test function •... - Page 5 LED INDICATOR STATUS Solid green Normal conditions, battery is charged / charging Slow flash green (1 sec on, 1 sec off) Self-test (function or duration test) underway Solid red Battery fault Slow flash red (1 sec on, 1 sec off) Lamp fault Fast flash red (0.25 sec on, 0.25 sec off) Failed duration test...
-
Page 6: Warranty
Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents which may damage the product. Do not use any source of high-pressure washers to maintain or clean this luminaire. This product is non-dimmable. This product should be dismantled for disposal when it reaches the end of its life. Please see website for dismantling instructions. - Page 7 Alternatively, simulate a mains supply failure for 3-hour continuous test by operation of key switch, or switching off circuit breaker. Ensure normal supply is restored after test and check status of bi-colour LED indicator • If the luminaire fails any of the above tests, please contact a qualified electrician. Results should be recorded, even when obtained via the self-test function.
- Page 8 230V IP65 50Hz °C SUPPLIED BY: (UK) MANUFACTURER (EU) AUTHORISED REPRESENTATIVE ML ACCESSORIES LTD, SLV LIGHTING GROUP, UNIT E CHILTERN PARK, DAIMLERSTRASSE 21-23, BOSCOMBE ROAD, DUNSTABLE 52531 ÜBACH-PALENBERG, GERMANY LU5 4LT, EMAIL: EPREL@GROUP.SLV.COM WWW.MLACCESSORIES.CO.UK AKDEC22_V1 MADE IN CHINA...
Need help?
Do you have a question about the TNXQUADSTW and is the answer not in the manual?
Questions and answers