Thermador Professional PRO-HARMONY PRD30 Installation Manual page 15

¥ ee
o 8 §
eo . e:-. a
F BEBE EEE EES 4 \
Ut BIS
Figure 9: Location of Gas Supply Inlet Connection on 48"
Ranges
as \ @ eee ee ee ee
SS
Zi,
° Lis
_ Step 6: Electrical
ery
Figure 8: Location of Gas Supply Inlet Connection Req Uu i rements, Con nection &
on 30" and 36" Ranges .
Grounding
* Prior to servicing appliance, always disconnect
appliance electrical supply cord, if so equipped, from
wall receptacle. If appliance is hard-wired to power
supply, disconnect power to unit by turning off the
proper circuit breaker or disconnecting the proper fuse.
Lock service panel to prevent power from being turned
ON accidentally.
Dual Fuel range models can be connected or hardwired to
the power supply as described on page 14.
Chart B: Electrical Supply Circuit Requirements
MODEL CIRCUIT
TYPE VOLTAGE RATING FREQUENCY PHASE
30" 240/208 VAC 35 Amps 60 Hz. Single
36" 240/208 VAC 35 Amps 60 Hz. Single
48" 240/208 VAC 50 Amps 60 Hz. Single
source (breaker/fuse panel) because critical range An improper 120/ 240 VAC power supply will
components, including the surface bumer spark cause malfunction, damage to this appliance,
reignition module, require 120 VAC to operate safely and possibly create a condition of shock hazard.
and properly.
A neutral supply wire must be provided from the power { WARNING
English 13