1 2 3 4 5
18
17
16
15 14 13 12 11 10 9
RC UNIT DISPLAY
1. Signal emitter icon. Appears when a control signal
is emitted.
2. Operating mode selection icon.
3. Vertical swing. Displayed when the button is
pressed "ЖАЛЮЗИ". (optional)
4. Timer ON. Displayed with the timer deactivated in
the 'timer on-off' mode (the icon will flash when the
timer is on) or in the 'timer on' mode.
5. Turbo mode icon. Appears when the TURBO button is
pressed in the cooling or heating mode; the fan speed
icon will flash.
6. RC lock indicator.
7. Fahrenheit / Celsius scale indicator.
8. Air stream speed:
9. AUH mode indicator (optional)
10. Horizontal swing. Displayed when the button is
pressed "ЖАЛЮЗИ" . (optional)
11. "IFeel" mode activation indicator.
12. "Health" mode activation indicator.
13. Low noise mode indicator. Displayed when the
QUIET button is pressed.
14. SELF - CLEANING mode activation indicator.
15. TIMER mode activation indicator.
33
16. Temperature setting. The set temperature is
displayed.
17. ECO function activation indicator. Displayed when
the ECO button is pressed.
6
18. "Children" function activation indicator.
7
4. CONTROLLING THE APPLIANCE
INSTRUCTIONS FOR USING THE REMOTE CONTROL
8
The remote control uses two AAA alkaline batteries.
-
Under normal conditions, the battery life is about
6 months. Use two new batteries of the same type
(pay attention to the poles when installing). After
replacing the batteries, use a pointed object (such
as the tip of a fountain pen) to press the button
«Сброс» (Reset).
The effective range of the remote control is about
-
8 meters.
When using the remote control, point the signal
-
emitter at the receiver of the indoor unit.
There should be no obstacles between the remote
-
control and the indoor unit. Pressing two buttons at
the same time will cause incorrect operation.
Do not use wireless equipment (such as a mobile
-
phone) near the indoor unit. If this causes
interference, please turn off the device, pull the
plug out of the socket, then plug it in and turn it on
after a while.
Do not drop the remote control. Do not place the
-
remote control in the direct sunlight or near the
oven.
Do not spray water or juice on the remote control,
-
use a soft cloth for cleaning. For safety reasons,
before disposing of the device, it is necessary to
remove the batteries from it and dispose of them.
Note:
In AUTO mode, the air conditioner adapts to the
-
heating or cooling mode according to the value d
- the difference between the room temperature and
the set temperature.
The night mode function is not available in AUTO
-
mode.
When the DRY mode is set, according to the value
-
O - the difference between the room temperature
and the set temperature, the air conditioner will
automatically start or stop the cooling operation
Need help?
Do you have a question about the NT-65CHB07 and is the answer not in the manual?