NewTek NT-65CHB07 Instruction Manual page 31

– Avoid fouling of the power cable plug. Always firmly
insert the plug into the power socket. A fouled or
loosely inserted plug can cause a fire or electric
shock.
– If the appliance will not be used for a prolonged
time, pull the plug from the power socket for safety
purposes.
– Do not attempt to turn the appliance off by using a
circuit breaker or pulling the plug from the socket –
the resulting sparks can cause a fire.
– The power cable plug should be fully and firmly
inserted into the socket. Otherwise the danger of
electric shock, overheating and even ignition is
present.
– Do not entangle, jam or pull by the power cable –
this may cause its damage. A defective power cable
can lead to electric shock or fire.
– Do not use extension cables and do not connect
the appliance to a socket to which other electric
appliances are connected.
– If any malfunctions should occur, first turn the
appliance off using the RC unit, then disconnect it
from power supply.
– Do not touch the moving louver blades. They may
jam your fingers, and this may аlso damage the
mechanism.
– Do not touch the buttons on the indoor unit with wet
hands.
– Do not insert sticks or any other foreign objects
into openings on the appliance's housings during
operation. This may lead to injury and to damage
to the appliance.
– Do not place any objects (especially vessels with
water or other liquids) on the outdoor or indoor unit.
– Do not wash the appliance with water as this may
cause electric shock.
– Frequently air the room if the appliance is operated
simultaneously with open flame appliances (gas
cookers, etc.). Insufficient ventilation may lead to
oxygen shortage.
– Do not allow the air stream to impact gas cookers
or burners.
– Never allow children to play with the appliance.
WARNING!
– Do not expose the appliance to direct sunlight.
– Do not block the air intakes and outlets as this will
decrease the cooling or heating efficiency and can
cause failure of the appliance.
– Prolonged exposure to a cold air stream will
adversely affect your physical condition and cause
health problem.
– Air the room after using the appliance.
– Close doors and windows while operating the
appliance, otherwise the cooling and heating
efficiency will be decreased.
– Do not install this appliance in facilities with high
humidity and in places where aggressive vapors
are discharged!
– In case of damage to the power cable or any other
part of the appliance immediately disconnect it
from the power supply system and apply to the
Manufacturer's service centre. In case of unskilled
intervention into the appliance or non-observance
of the operational requirements specified in the
present manual will void the warranty undertakings.
– This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety. Children should
be supervised to ensure that they do not play with
the appliance.
– Special conditions
implementation of split systems: it is necessary to
transport outdoor units of air conditioners ONLY in a
vertical position, indoor units can be placed during
transportation both horizontally and vertically.
Incorrect transportation can threaten the device
with a break in the tubes, as well as overflow of
compressor oil along the freon circuit. All these
factors provoke incorrect operation of the equipment
and its premature failure. If the external block of
the split-system was nevertheless transported in a
horizontal position (but by no means upside down!),
It must be placed vertically for several hours before
installation, without removing it from the original
packaging.
for transportation, the
30