2
Installation
2.1
Installation proposal
Outdoor/altitude operation
If the compressor is installed outdoors or if the ambient temperature can be below 0˚C (32˚F),
precautions must be taken. In this case, and also if operating at high altitude, consult Atlas
Copco.
Moving/lifting
16
Transport by a pallet truck
To prevent a tank-mounted model from falling over during transport by a pallet truck:
push the forks underneath the air receiver and place a wooden beam (1) (cross-section
approx. 4 x 6 cm / 1.6 x 2.4 in) through the supports on both sides of the receiver. While
holding the compressor, slowly lift the forks until the receiver is secured between the
beams.
Instruction book
2920 7170 31