Control Pedal - Roland GR-700 Owner's Manual

7
(3) Control Pedal
>For Synthesizer Output
Keyboard Amplifier, Monitor Amplifier
Vocal Amplifier, PA or Audio Equip-
ment.
»For Guitar Output
Guitar Amplifier
*It is possible to use the Normal Out of
the Guitar Controller to output direct
guitar sound, but using the Guitar Out
of the GR-700 will make the operation
more comfortable.
Pitch Bend function and VCF Cutoff
can be controlled by using the Boss Foot
Volume FV-200.
*Connect to the Output Jack of the
FV-200.
*Set the Minimum Volume to zero.
The Balanced Output Connector (9 is
used for setting up with the Balanced
type mixer or effect unit. If both this
connector and Guitar Output Jack @,
the connector output only synthesizer
sound. The rated output level is fixed
+4dB(max.)/600Q2. Also, the output from
this connector is transformless, so, to
convert into unbalanced output, open the
2nd pin and use 1st and 3rd pins.
In monaural set-up, be sure to mix the
output signal of the two channels with a
mixer.
*Remove the spring holder from the
FV-200. (Refer to the operation manual
of the FV-200 to see how to remove it)
*While not using the FV-200, unlatch it.
*You can use other Foot Volume but
may find it awkward compared to the
FV-200 because of the limited control
range, etc.
PITCH VCF
OROKOROKe)
FV-200