Sears Kenmore W10096996A Installation Instructions Manual page 3

9" wide gas (u.s.a. and 'canada) & electric (canada only) dryer
Table of Contents

Advertisement

Available languages

Available languages

IMPORTANT: The gas installation must conform with local codes, or in the absence of local codes, with the National Fuel Gas
Code, ANSI Z223.1/NFPA 54 or the Canadian Natural Gas and Propane Installation Code, CSA B149.1.
The dryer must be electrically grounded in accordance with local codes, or in the absence of local codes, with the National
Electrical Code, ANSI/NFPA 70 or Canadian Electrical Code, CSA C22.1.
WARNING:
For your safety, the information in this manual must be followed to minimize
the risk of fire or explosion, or to prevent property damage, personal injury, or death.
~ Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this
or any other appliance.
- WHAT TO DO IF YOU SMELL GAS:
e Do not try to light any appliance.
e Do not touch any electrical switch; do not use any phone in your building.
e Clear the room, building, or area of all occupants.
e Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's
instructions.
e If you cannot reach your gas supplier, call the fire department.
~ Installation and service must be performed by a qualified installer, service agency, or
the gas supplier.
WARNING:
Gas leaks cannot always be detected by smell.
Gas suppliers recommend that you use a gas detector approved by UL or CSA.
For more information, contact your gas supplier.
If a gas leak is detected, follow the "What to do if you smell gas" instructions.
IMPORTANT SAFETY INSTRUCTIONS
WARNING:
To reduce the risk of fire, electric shock, or injury to persons when using the dryer, follow basic precautions,
including the following:
@
Read all instructions before using the dryer.
@
Do not repair or replace any part of the dryer or attempt
Do not place items exposed to cooking oils in your dryer.
any servicing unless specifically recommended in this
items contaminated with cooking oils may contribute to
Use and Care Guide or in published user-repair
a chemical reaction that could cause a load to catch fire.
instructions that you understand and have the skills to
carry out.
@
Do not dry articles that have been previously cleaned in,
washed in, soaked in, or spotted with gasoline, dry-
@
Do not use fabric softeners or products to eliminate static
cleaning solvents,
or other flammable or explosive
unless recommended
by the manufacturer of the fabric
substances as they give off vapors that could ignite or
softener or product.
explode.
@
Do not use heat to dry articles containing foam rubber or
#
Do not allow children to play on or in the dryer. Close
similarly textured rubber-like materials.
supervision of children is necessary when the dryer is
w Clean lint screen before or after each load.
used near children.
m
Keep area around the exhaust opening and adjacent
Before the dryer is removed from service or discarded,
surrounding areas free from the accumulation of lint, dust,
remove the door to the drying compartment.
and dirt.
Do not reach into the dryer if the drum is moving.
@
The interior of the dryer and exhaust vent should be
w
Do not install or store the dryer where it will be exposed
cleaned periodically by qualified service personnel.
to the weather.
m@
See "Electrical Requirements" located in the installation
@
Do not tamper with controls.
instructions for grounding instructions.
SAVE THESE INSTRUCTIONS

Advertisement

Table of Contents
loading

Table of Contents