Table of Contents
Advertisement
Available languages
Available languages
(~
y p
2. Plan pipe fitting connection
2.Move dryer to final location
1
B
Cc
A. 3/8" flexible gas connector
C. 3/8" to 3/8" pipe elbow
B. 3/8" dryer pipe
D. 3/8" pipe-to-flare adapter fitting
A combination of pipe fittings must be used to connect dryer
to existing gas line. A recommended connection is shown.
Your connection may be different, according to supply line
type, size, and location.
Move dryer to final location. Avoid crushing or kinking vent.
After dryer is in place, remove cardboard from under the dryer.
( 3. Open shut-off valve
Open valve
(
1. Level dryer
Place level here
Place level here
Open shut-off valve in supply line; valve is open when handle
is parallel to gas pipe. Then, test all connections by brushing
on an approved noncorrosive leak-detection solution.
Bubbles will show a leak. Correct any leaks found.
CONNECT VENT
r
1. Connect vent to exhaust outlet
Check levelness of dryer from side to side.
Repeat from
front to back.
NOTE: The dryer must be level for the moisture sensing
system to operate correctly.
Not Level
LEVEL
Not Level
Using a 4"
(102 mm) clamp, connect vent to exhaust outlet
in dryer. If connecting to existing vent, make sure vent is
clean. Dryer vent must fit over dryer exhaust outlet and
exhaust hood. Check that vent is secured to exhaust hood
with a 4" (102 mm) clamp.
13
Advertisement
Table of Contents
