Table of Contents
Advertisement
Available languages
Available languages
C
2. Adjust leveling legs
If dryer is not level, prop up using a wood block, use wrench
to adjust legs up or down, and check again for levelness.
Once legs are level, make sure all four legs are snug against
the floor.
COMPLETE INSTALLATION
CHECKLIST
(-] Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
(]
Check that you have all of your tools.
[-] Dispose of/recycle all packaging materials.
(-] Check dryer's final location. Be sure vent is not crushed
or kinked.
(-] Check that dryer is level. See "Level Dryer".
[] Remove film on console and any tape remaining on dryer.
(] Wipe dryer drum interior thoroughly with a damp cloth
to remove any dust.
(]
Read "Dryer Use" in your "Use and Care Guide".
(-] Set the dryer on a
full heat cycle (not an air cycle) for
20 minutes and start the dryer.
if the dryer will not start, check the following:
@
Dryer is plugged into a grounded 3 prong outlet.
@
Electrical supply is connected.
@
Household fuse is intact and tight, or circuit breaker
has not tripped.
@
Dryer door is closed.
[-] When the dryer has been running for 5 minutes, open
the dryer door and feel for heat. If you feel heat, cancel
cycle and close the door.
If you do not feel heat, turn the dryer off and check
to see whether gas supply line shutoff valve is open.
@
(f the gas supply line shutoff valve is closed, open
it,then repeat the 5-minute test as outlined above.
@
|f the gas supply line shutoff valve is open, contact
a qualified technician.
NOTE: You may notice an odor when the dryer is first heated.
This odor is common
when the heating element is first used.
The odor will go away.
14
REVERSE DOOR SWING
(OPTIONAL)
if your door is the Large Side-Swing Door,
follow steps 1-6.
If your door is the Super Wide Side-Swing Door,
follow steps 1-13.
NOTE: Magnetized screw driver is helpful.
Large Side-Swing Door
(4 « Place towel on dryer
Open dryer door. Remove bottom screws from dryer cabinet
side of hinges. Loosen (do not remove) top screws from dryer
cabinet side of hinges.
Advertisement
Table of Contents
