Related Manuals for Congatec conga-STDA4
Summary of Contents for Congatec conga-STDA4
- Page 1 (Prototype Rev. X.0) Sample Distribution Set for congatec SMARC 2.1 Development Quick Start Guide Revision 1.00 Copyright © 2023 congatec GmbH ST4M_SDS_q100...
- Page 2 Sample Distribution Set for conga-STDA4 (Prototype Rev. X.0) and and this guide. In no event shall congatec GmbH be liable for any incidental, how to set it up.
- Page 3 These trademark holders are not affiliated with congatec GmbH, our products, or our website. congatec GmbH shall in no event be liable to the end user for collateral or consequential damages of any kind. congatec shall not otherwise be liable...
- Page 4 Sample Distribution Set Note 1. The conga-STDA4 (Prototype Rev. X.0) module variant included in the Sample Distribution Set depends on sample availability and customer request. 2. The conga-STDA4 Mass Production (MP) module variants will not provide the onmodule EEPROM and thermal sensors.
- Page 5 3. UHS microSD cards in an SD card adapter may not function. 4. DisplayPort is the default video output. 5. LVDS is not enabled in the dtb file by default. The conga-LDVI/EPI is not included in the sample distribution set. Copyright © 2023 congatec GmbH ST4M_SDS_q100...
- Page 6 Building the Image Boot Process To build the Linux operating system image for the conga-STDA4, follow the The conga-STDA4 boot process starts at Power On Reset (POR), where the hardware reset logic forces the ARM core to begin execution, starting from instructions described in the website below: the on-chip boot ROM of the processor.
- Page 7 The name of the kernel image file that is loaded To speed up the boot process significantly, install the root filesystem kern during boot process onto the onboard eMMC device. In case of questions, contact congatec ipaddr not specified Address of the system (used for network boot) technical support.
Need help?
Do you have a question about the conga-STDA4 and is the answer not in the manual?
Questions and answers