Subscribe to Our Youtube Channel
Related Manuals for Congatec conga-SMX8
Summary of Contents for Congatec conga-SMX8
- Page 1 Sample Distribution Set for congatec SMARC 2.1 Development Quick Start Guide Revision 1.0 Copyright © 2022 congatec GmbH SMX8_SDS_q10...
-
Page 2: Intended Audience
This quick start guide provides information about the contents of the and this guide. In no event shall congatec GmbH be liable for any incidental, conga-SMX8 sample distribution set and how to set it up. -
Page 3: Warranty
These trademark holders are not affiliated with congatec GmbH, our products, or our website. congatec GmbH shall in no event be liable to the end user for collateral or consequential damages of any kind. congatec shall not otherwise be liable... -
Page 4: Pinout Description
SMARC connector. 051050 conga-SMX8/i-CSP-B Passive cooling solution (051050) or heatspreader (051051) depending on customer Use the link below to directly download the conga-SMX8 pinout as an 051051 conga-SMX8/i-HSP-B request. All standoffs are with 2.7 mm bore hole. Excel file:... -
Page 5: Hardware Setup
2. LVDS is the default video output. Other video outputs (HDMI , eDP, or multi- ® screen) require a dtb file. 3. To enable serial downloader mode, set carrier board jumper X45 to position 2-3. Copyright © 2022 congatec GmbH SMX8_SDS_q10... -
Page 6: Building The Image
Boot Process Building the Image The conga-SMX8 boot process starts at Power On Reset (POR), where the hardware reset logic forces the ARM core to begin execution, starting from To build the Linux or Android operating system image for the conga-SMX8, the on-chip boot ROM of the processor. -
Page 7: Additional Information
Linux The following environment variables are predefined for conga-SMX8: Name Default value Description By default, the system boots the operating system that is stored on the microSD card. bootcmd Defines the startup command of the bootloader, i.e. how the system performs the boot process Booting to a graphical user interface (GUI) may take some time.
Need help?
Do you have a question about the conga-SMX8 and is the answer not in the manual?
Questions and answers