( T R A N S L AT I O N O F O R I G I N A L V E R S I O N D E ) KORMORAN PF V 180 / PF V HA 180 Addendum to the operating instructions 9901.00.17EN04...
Page 2
• Follow the safety instructions of the operating instructions for the basic machine. • Before start-up, read and take note of the operating instructions and addendum. • Retain for future reference.
PF V / VHA DDENDUM TO ORMORAN OPERATING INSTRUCTIONS SECTION: INTRODUCTION 2 - “S UPPLEMENT TO HAPTER AFETY INSTRUCTIONS AND ” RULES Re-tighten all bolts every 50 operating hours. 9998.06.40 SECTION: USE 3 - “D UPPLEMENT TO HAPTER ESCRIPTION OF THE ”...
PF V / VHA DDENDUM TO ORMORAN OPERATING INSTRUCTIONS 10 - “F ” UPPLEMENT TO HAPTER IELD ADJUSTMENT 10.10a Adjusting the Vari Heavy Duty skimmers depth - Use the diagram to determine gap H. Adjustment instructions H = factory setting: approx. 18 cm The Vari Heavy Duty working depth is calculated from the gap to the blade tip (H) Adjust H so that the cutting edge (a) works in the soil across...
PF V / VHA DDENDUM TO ORMORAN OPERATING INSTRUCTIONS SECTION: MAINTENANCE 14 - “T UPPLEMENT TO HAPTER ROUBLESHOOTING AND ” REPAIR 14.2a Replacing the Vari Heavy Duty (VHD) shear bolt Attachment - 3. Insert the new shear bolt from the link arm side. - 4.
PF V / VHA DDENDUM TO ORMORAN OPERATING INSTRUCTIONS Set-up information Safety information WARNING Risk of accident from crushing during set-up and adjustment work. Care must be taken during all work to ensure that the implement is stable and has been secured to prevent it rolling away.
Page 7
PF V / VHA DDENDUM TO ORMORAN OPERATING INSTRUCTIONS Set-up - Expanding the undercut Undercut - Check / adjust factory setting - 1. Position alignment rails (c) above coulter tips. - 1. Loosen beam screw (24). - 2. Loosen system screw (19). - 2.
Page 8
PF V / VHA DDENDUM TO ORMORAN OPERATING INSTRUCTIONS - 3. If value deviates from factory setting, adjust distance to alignment rail. Set all plough bodies uniformly. - 4. Loosen beam screw (24). - 5. Loosen system screw (19). - 6. Adjust the undercut (U) by turning the nuts (24) on the eyebolts.
PF V / VHA DDENDUM TO ORMORAN OPERATING INSTRUCTIONS 15 - „R ” HAPTER EPLACING WEAR PARTS the stripes Fastening Fastening Note Do not tighten the tapered screw to the standard tightening torque. Excess torque causes damage to the components. Torque In contrast to the torques for the standard threads, the tapered screws may only be tightened to 80 Nm.