Battery Removal; Using Your Vacuum; Controls And Cleaning Modes - Shark Cordless Detect Pro Vacuum Owner's Manual

BATTERY REMOVAL

REMOVING THE BATTERY
BATTERY
To remove the battery from the hand vacuum,
press the release tab on the battery cap and
slide out the battery� To reinstall, slide the
battery into the compartment in the handle
until it clicks into place�
STORAGE ON THE GO (IW1000 SERIES)
For quick and easy short-term storage, attach the hand vacuum to the wand by placing it
onto the pre-assembled wand storage clip�
12
s h a r kc l e a n . c o . u k

USING YOUR VACUUM

CONTROLS AND CLEANING MODES

POWER
Press the button on the UI Screen to
turn on power� To turn off power, press
the button again� To toggle between ECO,
DETECT, and BOOST modes, press the
mode selection button�
CLEAN INDICATOR
When the Detect Pro™ Indicator light is blue,
this means no heavy debris is detected and
suction power is normal� When the vacuum
senses heavy debris, the light will turn red, and
suction will increase for more cleaning power�
When the indicator light turns amber, debris
is being removed—continue cleaning until the
indicator turns blue again�
UPRIGHT
When upright, the nozzle will lock to allow
for freestanding storage when the hand vac
is detached� Place your foot on the nozzle to
disengage the lock to begin floor cleaning�
EDGE INDICATOR
When an edge is detected, the headlights
will illuminate the edge to focus on
targeted debris�
s h a r kc l e a n . c o . u k
13