en Troubleshooting
Fault
Excessive formation of
foam occurs.
Fault
Special salt refill indic-
ator lights up.
Refill indicator for spe-
cial salt does not light
up.
Refill indicator for
rinse aid lights up.
Refill indicator for
rinse aid does not
light up.
Fault
Water is left in the ap-
pliance at the end of
the programme.
Appliance cannot be
switched on or oper-
ated.
Appliance does not
start.
48
Cause and troubleshooting
Remove the rinse aid with a cloth.
▶
Detergent or appliance care product used causes ex-
cessive foaming.
Change the brand of detergent.
▶
Cause and troubleshooting
Insufficient special salt.
Add Special salt → Page 24.
▶
Sensor does not detect special salt tablets.
Do not use special salt tablets.
▶
Water softening system is switched off.
Set the water softening system.
▶
Insufficient rinse aid.
Add Rinse aid → Page 26.
1.
Set the amount of rinse aid to be dispensed.
2.
Rinse aid system is switched off.
Set the amount of rinse aid to be dispensed.
▶
Cause and troubleshooting
Filter system or area under the filters is blocked.
Clean the Filters → Page 37.
1.
Clean the Wastewater pump → Page 51.
2.
Programme has not yet ended.
Wait until the programme ends or cancel the pro-
▶
gramme with Reset.
→ "Terminate programme", Page 34
▶
Appliance functions have failed.
Pull out the mains plug or switch off the fuse.
1.
Wait at least 2 minutes.
2.
Connect the appliance to the power supply.
3.
Switch the appliance on.
4.
The mains fuse has tripped.
Check the relevant fuse.
▶
Mains cable is not inserted.
Check whether the socket works.
1.
Check whether the mains cable is properly inserted
2.
in the socket and on the rear of the appliance.