Table of Contents
Advertisement
en Water softening system
Water hardness
°E
27 - 38
39 - 44
Note: Set the water hardness determ-
ined on your appliance.
→ "Setting water softening system",
Page 24
With a water hardness of 0 - 8 °E
you can dispense with special salt
and switch off the water softening
system.
→ "Switching off water softening sys-
tem", Page 25
11.2 Setting water softening
system
Set the water hardness on your appli-
ance.
Determine the water hardness and
1.
the appropriate setting value.
→ "Overview of water hardness set-
tings", Page 23
Press
.
2.
Hold programme button A and
3.
press
repeatedly until the dis-
play shows H:xx.
Release programme button A and
4.
.
Programme button A flashes and
a
the display shows H:04.
Press programme button C re-
5.
peatedly until the right water hard-
ness has been set.
Press
to save the setting.
6.
11.3 Special salt
You can use special salt to soften
water.
Adding special salt
If the special salt refill indicator lights
up, add special salt to the dispenser
for special salt just before the pro-
24
Hardness range
Hard
Hard
mmol/l
3.8 - 5.4
5.5 - 6.2
gramme starts. The amount of spe-
cial salt required depends on the wa-
ter hardness: the higher the water
hardness, the greater the amount of
special salt required.
ATTENTION!
Detergent may damage the water
softening system.
Only fill the dispenser of the water
▶
softening system with special dish-
washer salt.
Special salt can damage the tub due
to corrosion.
To make sure that any special salt
▶
that escapes is washed out of the
tub, add the special salt to the dis-
penser for special salt immediately
before the programme starts.
Unscrew the lid of the dispenser
1.
for special salt and remove.
On initial start-up: Fill the dispenser
2.
right up with water.
Setting value
H:06
H:07
Advertisement
Table of Contents
