10 Decommissioning; Dismantling The Ups - Beckhoff CU8110-0060 Manual

10 Decommissioning

10.1

Dismantling the UPS

Electrical voltage
If the power supply is switched on during dismounting, this can lead to damage to the UPS. Switch off the
power supply during dismounting.
This chapter shows how to disassemble the UPS and thus remove it from the DIN rail. Shut down the
industrial PC connected to the UPS so that the UPS is switched off.
Requirements:
• Switch off the power supply.
Dismantle the UPS as follows:
1. Push the UPS upwards.
ð As soon as you push the UPS upwards, the lower springs of the DIN rail adapters give way. This
allows the UPS to be released from the top edge of the DIN rail.
2. Tilt the UPS forwards.
ð The UPS can be removed from the DIN rail.
CU8110-0060
NOTICE
2
1
Version: 1.0
Decommissioning
47