Beckhoff CU8110-0060 Manual page 32

Configuration
Setting or Value range
function
Last service -
date:
01.01.11*
Next service -
date:
01.01.16*
Reset service -
interval
remainder...
update to: -
25.05.12*
Update -
firmware...
Self test -
Factory -
Defaults
OK -
Cancel -
*) Example value.
32
Default value Description
- Shows the actual set battery replace/service date (last
service on 1 January 2011).
- Shows the estimated next battery replace/service date
(next service on 1 January 2016).
- Updates the record of the most recent battery change
and resets the service interval remainder messages. The
date is stored in the UPS's EEPROM, and can be
examined in the UPS information dialog.
- Shows the suggested service interval update date shown
in the "Reset service interval" command dialog (25 May
2012).
- Starts a firmware update.
- Executes a self-test and displays the result:
• "OK" - Test successful, the battery is OK;
• "BT" - Failed because the battery capacity was
insufficient, or because a battery is not even present;
• "NG" - Failed as a result of overload;
• "NA" - Test function does not exist;
- Restores the factory (default) settings. The default battery
type setting is: C9900-U330. Please check your real
battery type configuration.
- Saves all settings and closes the dialog. Don't forgett to
apply the changes at the Beckhoff UPS Configuration
dialog too.
- Discards all editable changes.
Version: 1.0 CU8110-0060