4. Locate the green connectors with general purpose output terminals marked
GPIxx. Check the polycarbonate protective sheet to identify the terminals.
GPI/PWR OUT/RS485
GPI03 GPI02 GPI01
5. Connect the cable wires to the connector by inserting the wires into the green
terminal and pressing the orange locking mechanism.
6. Connect the signal input wire to the GPI terminal and the ground wire to the
GND terminal, as shown in the above figure (step 4).
GPI00
PWR OUT*
RS485
GND A
GND GPI
GND SV GND 24V NC
B
Using GPIO interface 65