Table of Contents
Advertisement
3. Determine the correct mounting orientations. See the example of correct and
incorrect orientations shown in below figures:
Correct orientation
1
Drive end (DE)
2
Non-drive end (NDE)
Make sure that:
•
Y-axis is parallel to the shaft and the arrow points to the NDE.
•
X-axis is vertical to the motor base pointing against it.
•
Z-axis points away from the motor.
4. Stick the plastic enclosure on the glued motor surface and hold until the glue
sets (approximately 10 minutes).
Note:
•
The glue achieves its full strength after a few hours. See specifications of
®
Loctite
AA 326 (page
•
The motor fin mounting pads are not included in the package. You must
order them separately.
Installing the Magnetic Field Sensor 45
Incorrect orientation
72).
Advertisement
Table of Contents
