Scandomestic SKB10255W User Manual page 51

TL-19AA/TL-20AAA reverse door
Note: When installing the door, ensure that the top of the door is level with the top of the cabinet. If
the door is not level, the rubber gasket will not make a good seal with the cabinet which can cause
the appliance to malfunction.
Reverse the door swing
English
1 Before reversing
direction, unplug the appliance and remove
all food.
2 Using a flat screwdriver pry and remove
hinge caps (if appropriate).
3 Using a Phillips screwdriver remove the door
upper hinge while holding the door (step.
1).
4 Tilt the appliance (up to 40 degrees) to have
sufficient access to the lower hinge (step. 2).
5 Using a Phillips screwdriver, remove the
lower door hinge.
6 Attach the lower hinge on the other side
(step. 3).
7 Position the door assembly in such a way so
that pin of the lower hinge is aligned with
the appropriate hole of the lower doo r
bracket.
8 Attach the middle hinge on the other side of
the appliance so that the lower pin of the
middle hinge is aligned with the appropriate
hole of the upper door bracket. Position the
second door assembly so that the upper pin
of the middle hinge is aligned with the
appropriate hole of the lower door bracket
(step 4).*
9 Check that the door is properly aligned with
the cabinet.
10 Switch on the appliance as described in the
relevant section
instructions.
*This action applies to products with both
refrigeration and freezer chambers.
23
the door's opening
of its operating