Cub Cadet 2000 Series Professional Shop Manual page 51

Figure 5.14
Bow tie clip
Brake pedal shaft
Drive pedal shaft
Figure 5.15
Control rod
Figure 5.16
Cotter pin
Brake rod
Bow tie clip
5e. Disconnect the brake rod from the brake pedal
shaft by removing and discarding the cotter pin.
See Figure 5.14.
5f. Pull back on the brake rod and maneuver it past
the brake shaft and forward drive shafts.
5g. Unhook the brake rod from the brake spring.
6. Remove the drive control rod:
6a. Remove the bow tie clip that holds the drive
control rod and spring to the bell crank on the
pedal shaft. See Figure 5.15.
6b. Remove the bow tie clip that holds the drive
control rod to the hydro pump. See Figure 5.16.
6c. Slide the control rod off of the pin.
Drive
45