Cub Cadet 2000 Series Professional Shop Manual page 13

Figure 2.5
Grip
Figure 2.6
Screw
Figure 2.7
NOTE: On the GTX2154LE:
• Remove the four screws, indicated by the arrows
in Figure 2.5, that hold the seat frame to the fender
using a 7/16" wrench.
• Remove the two screws that hold the rear of the
fender to the frame using a 7/16" wrench.
On manual deck lift models:
5. Remove the deck lift lever grip. See Figure 2.6.
NOTE: A blow-gun with air pressure regulated to less than
25 PSI (1.72 Bars), may be inserted into the small
hole at the end of a rubber grip to inflate it slightly,
easing removal.
On electric deck lift models:
6. Remove the screw that holds the deck cutting height
lever to the shaft using a T40 torx driver.
7. Pull the cutting height lever off of the shaft.
8. Disconnect the deck lift switch.
Engine Related Parts
7