Cub Cadet 2000 Series Professional Shop Manual page 35

Screws
Figure 4.10
Locating tab
Lock tabs
Figure 4.11
6. Remove the two screws that hold the pivot bracket
and grille to the hood assembly using a 3/8" wrench.
See Figure 4.10.
7. Unlatch the tabs, where the screws were in step 3,
while pushing the grille out of the hood.
8. Once removed, the headlight lens may be removed
for cleaning by carefully prying the two lock tabs at
the inner edge. See Figure 4.11.
NOTE: The locating tab at the outer edge of each lens has
no locking feature.
9. Assemble and install the grille by reversing the steps
used to remove it.
• Tighten the small screws to a torque of 15-35 in-
lbs. (1.7-4.0 N-m).
• Tighten the large screws to a torque of 35-50 in-lbs
(4.0-5.7 N-m).
Body
29