Transmission Removal/Replacement - Cub Cadet 2000 Series Professional Shop Manual

2000 Series Tractors

Transmission removal/replacement

To remove/replace the transmission:
1. Remove the deck as described in Chapter 8 Cutting
Decks and Lift Shaft.
NOTE: If the transmission is being removed to open
it up, drain the fluid at this point by following
the procedures described in the transmis-
sion fluid change section of this chapter.
2. Lift and safely support the rear of the tractor.
3. Remove the nut that secures the anti-sway rod to
the transmission torque bracket. See Figure 5.11.
4. Slide the anti-sway rod out of the torque bracket.
5. Remove the brake rod:
5a. Remove the E-ring, bushing and washers
from the right side of the forward drive pedal
shaft. See Figure 5.12.
5b. Slide the drive pedal shaft to the left until it
clears the frame.
NOTE: Let the drive pedal shaft hang there.
5c. Remove the E-ring and washer(s) from the
right side of the brake pedal shaft.
See Figure 5.13.
5d. Slide the brake pedal shaft to the left until it
stops.
44
Figure 5.11
E-ring
Drive pedal shaft
Brake pedal shaft
Figure 5.12
Figure 5.13
Anti-sway bar
E-ring