Table Of Contents; Introduction - Husqvarna 325iLK Operator's Manual

Introduction..................................................................... 6
Safety..............................................................................7
Assembly...................................................................... 11
Operation...................................................................... 12
Maintenance................................................................. 12
Intended use
This power unit is a bare unit that only function
together with approved accessories, see those approved
Product overview
(Fig. 1)
1. Operator's manual
2. 4 mm hex
3. Loop handle
4. Knob
5. User interface
6. Start/stop button
7. Speed mode button
8. Power trigger lockout
9. Keypad
10. Power trigger
11. Battery charger cord
12. Battery charger
13. Power and Warning LED
14. Battery release buttons
15. Battery
16. LED indicator for the state of charge
17. Warning LED
18. Battery indicator button
19. Coupling for attachment
Symbols on the product
(Fig. 2)
WARNING! This product can be
dangerous! Careless or incorrect use
can result in serious or fatal injury to
the operator or others. It is extremely
important that you read and understand
the contents of the operator's manual.
Please read the operator's manual
carefully and make sure you understand
the instructions before the product is
used.
(Fig. 3)
Maximum speed of the output shaft.
(Fig. 4) Rated voltage, V
6
Contents
Troubleshooting............................................................ 13
Transportation, storage and disposal........................... 14
Technical data.............................................................. 14
Accessories.................................................................. 16
Declaration of Conformity............................................. 17

Introduction

accessories in
read this manual together with the approved accessory
manual.
(Fig. 5)
(Fig. 6)
(Fig. 7)
(Fig. 8)
(Fig. 9)
yyyywwxxxx
Note:
Other symbols/decals on the product refer to
certification requirements for other commercial areas.
Manufacturer
Husqvarna AB
Drottninggatan 2, SE-561 82 Huskvarna, Sweden, tel:
+46-36-146500
Product damage
We are not responsible for damages to our product if:
• the product is incorrectly repaired.
• the product is repaired with parts that are not
from the manufacturer or not approved by the
manufacturer.
• the product has an accessory that is not from the
manufacturer or not approved by the manufacturer.
Accessories on page 16 . Make sure to
Direct current.
The product agrees with the applicable
EC directives.
This product conforms to the applicable
UK regulations.
Symbols on the product or its packaging
indicate that this product cannot be
handled as domestic waste. This product
must be deposited at an appropriate
recycling facility.
Do not use in rain.
The rating plate shows the serial num-
ber. yyyy is the production year, ww is
the production week and xxxx is the
sequential number.
1318 - 009 - 27.09.2023