Table of Contents
Advertisement
deTroubleshooting
Disturbance
In the chamber
there is residual water
ser.
Vibrations and movement
the device during
spinning.
drum turns,
Water doesn't come in.
Strong foaming
dung.
High spin speed
number is not
reached.
Spin program
does not start.
46
Cause and troubleshooting
be-
Insert in chamber is clogged.
→ "Cleaning the detergent drawer", page 35
▶
Device is not aligned correctly.
→
"Aligning the device", page 17
▶
Device feet are not fixed.
Fix the device feet.
▶
→
"Aligning the device", page 17
Transport locks have not been removed.
→ "Remove transport locks", page 14 .
▶
Load detection is active.
No error, no action necessary.
▶
A notice:Load detection can take up to 2 minutes.
Detergent dosage is too high.
Immediate measure: Mix a tablespoon of fabric
▶
softener with 0.5 liters of water and fill the mixture
into chamber II (not for outdoor, sportswear and
down textiles).
The next time you wash the same load, reduce the
▶
amount of detergent.
Low spin speed is set.
Set a higher spin speed for the next wash cycle.
▶
Unbalance control system compensates for unbalance
by reducing the spin speed.
Redistribute the laundry in the drum.
▶
A notice:If possible, place large and small items of
laundry together in the drum. Different sized items of
laundry are distributed better when spinning.
Start the programCentrifuge / Essorage.
▶
Drain pipe or water drain hose is blocked.
Clean the drain pipe and water drain hose.
▶
Drain pipe or water drain hose is kinked or pinched.
Advertisement
Table of Contents
