Siemens WM14N2M4FG Manual page 43

Disturbance
All other error codes
of.
Device works
not.
Program starts
not.
Door cannot be
opened.
Cause and troubleshooting
Malfunction
Turn the device off and on again.
1.
If the message appears again, disconnect the device
2.
from the power supply for at least 30 seconds by
pulling out the plug or switching off the associated
fuse in the fuse box.
aIf the fault was a one-time occurrence, the message goes out
dung.
If the message appears again, call customer service.
3.
When calling, provide the exact error message.
→
"Customer Service", page 51
The mains plug of the mains connection cable is not plugged
in.
Connect the device to the power supply.
▶
The fuse in the fuse box has tripped.
Check the fuse in the fuse box.
▶
Power supply has failed.
Check whether the room lights or other devices in
▶
the room are working.
Start/Pauze / Départ/Breakwas not pressed.
PressStart/Pauze / Départ/Break.
▶
Door is not closed.
Close the door.
▶
Parental controls are activated.
Disable parental controls.
▶
→ ""Deactivate parental controls", page 33
Clear in / Fin dansis activated.
check ifClear in / Fin dansis activated.
▶
→
"Buttons", page 23
Laundry is jammed in the door.
Remove any trapped laundry.
▶
- - - is activated.
Continue the program byCentrifuge / Essorageor
▶
Afpompen / Vidangechoose andStart/Pauze /
Départ/Breakpress.
→
""Continue program when rinsing stops", page 33
Temperature is too high.
Wait until the temperature has dropped.
▶
Troubleshootingde
43