Electrical Connection; Performance Checklist - Viking Professional VGSO166SS Installation Instructions Manual

Electrical Connection

There is no connection necessary beyond plugging the unit into a polarized, grounded, 120 volt, 60 Hz, 15 amp circuit.
This circuit, however, MUST be grounded and properly polarized. The unit is equipped with a 16-3 SJT power cord,
and if an extension is required, it must be of at least this gauge.
NOTE: If electrical power is not supplied or interrupted, the oven burners and the broiler will not work. D D O O N N O O T T
A A T T T T E E M M P P T T to operate the appliance during a power failure.
This appliance is equipped with a 3-prong grounding plug for your protection against shock hazard and should be
plugged directly into a properly grounded socket. Do not cut or remove the grounding prong from this plug.
If the unit is not grounded or if polarity is reversed, severe shock hazard can exist.
Initial Ignition of Burners
All ovens are tested before leaving the factory. When the oven is connected to the gas supply and the electrical
service, the installer should use the "Performance Checklist" for his final checks.
When adjustments are required, contact your dealer/installer for corrections. If assistance is not available, contact
Viking Range Corporation Preferred Service for the nearest authorized service agent at (662) 451-4133. All corrections
to installation are the responsibility of the dealer/installer or end user.

Performance Checklist

The installer should carry out the following performance checks. Refer to instructions below.
1. Check oven ignition, bake, and broiler burners.
2. Check air shutter adjustment; sharp blue flame,no yellow tipping, no sooting, no flame lifting.
3. Visually check tubular burner reignition to be sure both sides are relighting each time.
4. Visually check for glowing infrared broiler screen.
5. Check for gas leaks (odor) at all gas connections.
6. Check convection fan switch and fan operation.
7. Check light switch and light operation.
8. Check for proper fit of door seals.
WARNING!!
ELECTRICAL GROUNDING INSTRUCTIONS
WARNING!!
10