Viking Professional VGSO166SS Installation Instructions Manual page 5

Double Installation (Two Single Cutouts)
•Use IKD-VGSO double installation gas connection kit.
1. For cabinet preparation, see cabinet cutout dimensions (p.4).
2. Install upper oven as described on p. 4, "Cabinet Mounting for Single Oven".
3. Place the bottom oven on a protected area near the cabinet.
•Remove 2" hole knockout from oven top.
•Remove access panel (5) from oven side.
•Remove pipe plug (6) from pipe tee (7).
•Attach male connector (8) on flex tubing (9) to pipe tee (7).
•Attach flex tubing (9) to male connector (8).
•Replace access panel (5).
4. Slide lower oven into cabinet.
•Remove all knobs, push button and bezels.
•Remove lower access panel (1), side trim (2), and control panel trim (3), and insert 4 wood screws.
(see single oven mounting)
•Remove control box (10) disconnecting the 3 harness connectors (11).
•Attach 8" (20.3 cm) pipe nipple (12) thru the lower oven cabinet into the upper oven pipe tee (13).
•Attach female connector (14) on flex tubing (9) to 8" (20.3 cm) pipe nipple (12).
•Attach flex tubing (9) to female connector (14).
•Connect gas supply as describe in section "GAS CONNECTION" (page 6).
• Check all connections for gas leaks.
•Reconnect 3 harness connectors (11) and replace control box (10).
•Replace side trim (2), control panel trim (3), and lower access panel (1).
•Replace knobs, push buttons, and bezels.
DCT-VGSO-SS (Optional Center Trim ) Installation
A. Install mounting brackets (1) between the ovens on both sides.
B. Insert center trim (2) over mounting brackets.
35"
5
(See illustration below)