Progress PKG1453 User Manual page 7

Overall dimensions ¹
H1 mm
W1 mm
D1 mm
¹ the height, width and depth of the
appliance without the handle and feet
Space required in use ²
H2 (A+B) mm
W2 mm
D2 mm
A mm
B mm
² the height, width and depth of the
appliance including the handle, plus the
space necessary for free circulation of the
cooling air
Overall space required in use ³
H3 (A+B) mm
W3 mm
D3 mm
³ the height, width and depth of the
appliance including the handle, plus the
space necessary for free circulation of the
cooling air, plus the space necessary to
allow door opening to the minimum angle
permitting removal of all internal
equipment
Location
To ensure appliance's best functionality,
you should not install the appliance in the
nearby of the heat source (oven, stoves,
radiators, cookers or hobs) or in a place
with direct sunlight. Make sure that air can
circulate freely around the back of the
cabinet.
Positioning
This appliance should be installed in a dry,
well ventilated indoor position.
1441
This appliance is intended to be used at
548
ambient temperature ranging from 10°C to
549
43°C.
1482
548
551
1446
36
Electrical connection
• Before plugging in, ensure that the
1482
voltage and frequency shown on the
548
rating plate correspond to your
domestic power supply.
1071
• The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the
domestic power supply socket is not
earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a
qualified electrician.
• The manufacturer declines all
responsibility if the above safety
precautions are not observed.
• This appliance complies with the E.E.C.
Directives.
Ventilation requirements
The airflow behind the appliance must be
sufficient.
The correct operation of the
appliance can only be
guaranteed within the specified
temperature range.
If you have any doubts
regarding where to install the
appliance, please turn to the
vendor, to our customer service
or to the nearest Authorised
Service Centre.
It must be possible to
disconnect the appliance from
the mains power supply. The
plug must therefore be easily
accessible after installation.
Progress 7