Test Equipment Required - Tektronix S-4 Instruction Manual

Section 4—S-4 Sampling Head
This performance check andcalibration procedure for the
Type S-4 Sampling Head requires the use of the test equip-
mentlisted below. The test equipment specifications given
correctly calibrated.
Table 4-1
TEST EQUIPMENT REQUIRED
item. If other test equipment is substituted, it must meet or
exceed the stated requirements. All test equipment must be
Signal/Pulse Generator
Pulse Generator
Rigid Coax line, 3 mm connectors
GR874 to 3mm adapter plug
GR874 to 3 mm adapterjack
50 2 2X coaxial attenuator, GR874
connectors
Special variable attenuator with GR
connectors
bne 50 2 cable approximately 40
inches long.
bnc to bsm cable approximately 18
inches long
Special 3 foot extender cable for
sampling head
Pulse rise time 70 ps or or less, amplitude
approximately 20 mV into 50 Q. Trigger 180 mV
positive going at least 75 ns in advanceof pulse
with risetime of <400 ps. Square wave outputs
of 1 us and 1 ns with 100 mV and 1.0 V
amplitude into 50 Q.
rise time 25 ps or less, amplitude =>200 mVinto
50 2 with 180 mV positive goingtrigger at least
75 ns in advanceof the fast pulse.
Test Procedures
Response not guaranteed
(2 required)
Tektronix Type 284
Tektronix Type S52
Tektronix Part No. 015-1015-00
015-1007-00
015-1008-00
017-0080-00
Tektronix Part No.
Tektronix Part No.
Tektronix Part No.
Tektronix Part No. 067-0511-00
Tektronix Part No. 012-0057-01
Tektronix Part No. 012-0127-00
Tektronix Part No. 012-0124-00