Table of Contents
Advertisement
WASHING PROCEDURE
Use lukewarm water and mild detergent on the
painted components to remove dirt, etc.
Clean motorcycle thoroughly with plain water to
remove the detergent.
Never spray water towards bottom side of instrument
cluster directly to avoid water entry through breather
holes.
If possible, use compressed air and blow off water par-
ticles from the obscure areas of the motorcycle, elec-
trical connections etc.
Once the motorcycle has been ridden in salty
conditions (i.e. during winter in places where road salt
is used) or near coastal areas it is recommended to
wash your motorcycle with cold water after the ride to
prevent corrosion or rust build-up. Please do not use
warm water for washing as it may damage the motor-
cycle due to chemical reaction with the salt. After
washing process once the motorcycle is completely
dry it is recommended to apply anti-corrosion spray
on all the metal and chrome plated areas to protect
the parts from corrosion.
It is recommended not to apply the anti-corrosion
spray on the brake discs.
Do not use petrol, brake oil or other flammable
liquids to clean or wash on electronic parts.
The parts chosen using motorcycle configurator
should not be washed with soap or chemical, use only
with plain water.
No direct jet at the edges of decal, electrical parts,
coupler joints, silencer tail pipe, radiator lubrica-
tion points like steering cone kit, brake pedal, wheel
bearings, chain, brake cam & swing arm bushes to be
washed in spray mode only (not in jet mode).
Royal Enfield Meteor 350
97
Advertisement
Table of Contents
