Table of Contents
Advertisement
MINOR MAINTENANCE TIPS
Slide the caliper assembly
into the swing arm.
Assemble chain adjuster
assembly into swing arm LH.
Insert spindle with tommy
bar into rear wheel hub LH
along with washer.
Install washer into spindle
RH. Assemble hex nut and
tighten into swing.
NOTE
Do not tighten hex nut fully.
Tighten chain adjuster nuts on left
and right adjuster such that the
index marks are aligned correctly
on both sides of the swing arm.
Check and ensure correct chain
tension and wheel alignment.
Ensure the lines are matched
with the lines punched in
swing arm on both LH &
RH side for proper wheel
alignment.
Once chain free play is
verified, hold spindle LH with
tommy bar and tighten the wheel axle nut.
CAUTION
Please exercise utmost caution
while reassembling the rear wheel
on the motorcycle.
Please ensure the wheel is fitted
correctly before attempting to ride
the motorcycle.
Failure to do so will result in poor performance of
motorcycle which may lead to an accident causing injury to
you / other road users and may lead to loss of life.
Royal Enfield Meteor 350
77
Advertisement
Table of Contents
