NIC Configuration
Link Speed
Use this feature to specify the port speed for this port. The options are Auto Negotiated,
10 Mbps Half, 10 Mbps Full, 100 Mbps Half, and 100 Mbps Full.
Wake On Lan
Use this feature enable or disable Wake On Lan support. Wake On Lan allows the sys-
tem to wake up when an onboard LAN device receives an incoming signal. The options
are Disabled and Enabled.
Blink LEDs (range 0–15 seconds)
Use this feature to identify the physical network port by blinking the associated LED.
Highlight this feature and enter a number of seconds in the range of 0 to 15 to set the
amount of seconds to blink the LED. The default setting is 0.
The following information is displayed:
•
UEFI Driver
•
Adapter PBA
•
Device Name
•
Chip Type
•
PCI Device ID
•
PCI Address
•
Link Status
•
MAC Address
•
Virtual MAC Address
Driver Health
This submenu displays the health of the LAN and its related controller.
95
Chapter 4: UEFI BIOS