Supermicro X13SCL-F User Manual page 50

Super X13SCL-F User's Manual
ME Manufacturing Mode
Close pins 2–3 of jumper JPME2 to bypass SPI flash security and force the system to operate
in the manufacturing mode, which will allow the user to flash the system firmware from a host
server for system setting modifications. Refer to the table below for jumper settings. The default
setting is Normal.
Watchdog Timer
Watchdog (JWD1) is a system monitor that can reboot the system when a software application
hangs. Close pins 1–2 to reset the system if an application hangs. Close pins 2–3 to generate
a non-maskable interrupt (NMI) signal for the application that hangs. Refer to the table below
for jumper settings. The Watchdog must also be enabled in the BIOS.
UID-SW
MH6 UID-LED
MH2
BMC
LEDM1
2
1
MH11
22110
B1
MH10
2280
JBT1
+
CMOS CLEAR
MH12
MH3
PCH
SATA1
262
M.2-P
M.2 NVME
FANB
MH7
JL1 USB8(3.0)
SATA7
CHASSIS INTRUSION
ME Manufacturing Mode
Jumper Settings
Jumper Setting Definition
Pins 1–2 Normal (Default)
Pins 2–3 Manufacturing Mode
Watchdog
Jumper Settings
Jumper Setting Definition
Pins 1–2 Reset (Default)
Pins 2–3 NMI
Open Disabled
VGA
USB6/7(3.0)
LAN2 LAN1
USB0/1
BMC_LAN
CPU
USB9/10(3.0)
JSEN1
FAN4 FAN3
FANA
50
COM1
1. ME Manufacturing Mode
MH1
2. Watchdog Timer
JPWR2
BIOS LICENSE
MH4
FAN2 FAN1
MH5