Hardware Description; Product Overview; Layout; Mechanical Installation - ABB ACS480 Hardware Manual

156 BIO-01 I/O extension module

Hardware description



Product overview

The BIO-01 front option module (Option +L515) is an I/O extension module to be
used with fieldbus. The BIO-01 option module is installed between the drive and the
fieldbus module. The BIO-01 has three additional digital inputs (DI3, DI4 and DI5),
one analog input (AI1) and one digital input (DO1) that is referred as DIO1 in the
firmware (but works only in output mode). You can use DI4 and DI5 as frequency
inputs and DO1 as a frequency output.
BIO-01 terminal block is removable and uses spring clamps for assembly.


Layout

Mechanical installation

Refer to Option modules
Before you install the BIO-01 option module, make sure that the chassis screw slider
is in the top position. After the option module is installed, tighten the chassis screw
and move the slider to the bottom position.
The BIO-01 option module kit comes with a higher cable clamp plate. Use this cable
clamp plate to ground the wires that connect to the BIO-01 option module.
Note: If you power up the drive before you install the BIO-01 option module or a
fieldbus module, the drive gives a warning.
1
2
3
on page 69.
1. Locking tab
2. Option module slot
3. Chassis screw
4. I/O connector
4