Table of Contents
Advertisement
NOTE:
If a memory profile has not already been set, refer to "Programming The Memory Feature" in
this section for instructions on how to set a memory profile.
3. Once the profile has been recalled, push and release the SET (S) button on the memory
switch.
4. Push and release button (1) or (2) accordingly. "Memory Profile Set" (1 or 2) will display in the
instrument cluster.
5. Push and release the LOCK button on the RKE transmitter within 10 seconds.
NOTE:
Your RKE transmitters can be unlinked to your memory settings by pushing the SET (S) but-
ton, and within 10 seconds, followed by pushing the UNLOCK button on the RKE transmitter.
Memory Position Recall
NOTE:
The vehicle must be in PARK to recall memory positions. If a recall is attempted when the
vehicle is not in PARK, a message will be displayed in the EVIC.
To recall the memory settings for driver one, push MEMORY button 1 on the driver's door or the
UNLOCK button on the RKE transmitter linked to memory position 1.
To recall the memory setting for driver two, push MEMORY button 2 on the driver's door or the
UNLOCK button on the RKE transmitter linked to Memory Position 2.
A recall can be cancelled by pushing any of the MEMORY buttons on the driver's door during
a recall (S, 1, or 2). When a recall is cancelled, the driver's seat, and the pedals (if equipped) stop
moving. A delay of one second will occur before another recall can be selected.
NOTE:
Pushing the mirror adjust switch will cancel the memory mirror recall.
Easy Entry/Exit Seat (Available With Memory Seat Only)
This feature provides automatic driver seat positioning to enhance driver mobility when entering
and exiting the vehicle.
The distance the driver seat moves depends on where you have the driver seat positioned when
you remove the key from the ignition switch.
• When you remove the key from the ignition switch, the driver seat will move about 2.4 inches
(60 mm) rearward if the driver seat position is greater than or equal to 2.7 inches (67.7 mm)
forward of the rear stop. The seat will return to its previously set position when you insert the
key into the ignition switch and turn it out of the LOCK position.
G E T T I N G S T A R T E D
29
Advertisement
Table of Contents
