Table of Contents
Advertisement
TH-65PB2E
Note: when Front Glass is exchanged
• Paste the Front Glass Sponges in order along each
Glass Holder Assy left and right, top and bottom.
Note
• The sponges are parts which cannot be recycled. Please
use the new article when you exchange the Front Glass.
8.20.2. Removal of V1-Board and V2-Board
1. Remove the screws and then remove the Glass Holder
Assy (left, right, bottom).
2. Remove 1 screw (E).
3. Disconnect the connector (V11) and then remove V1-
Board.
4. Remove 3 hooks and then remove the Power Button and
Power Button Spring.
5. Disconnect the connector (V22) and then remove V2-
Board.
6. Remove 2 hooks and then remove the 5 Key Button from
V2-Board.
8.20.3. Removal of Cabinet Assy
1. Remove the Front Glass.
(Refer to Removal of Front Glass)
2. Remove V1-Board and V2-Board.
(Refer to Removal of V1-Board and V2-Board)
3. Remove the LED Panel, Photo IC Receive Panel and
Remote Sensor Panel, and then remove the Cabinet
Assy.
8.21. Removal of Plasma Display
Panel
• The C1, C2, C3 Boards are connected with the plasma
display panel for the repair.
• About the enclosed thing for line processing of the
plasma display panel for repair
Although two kinds of enclosed things for line processing are
contained in the plasma display for repair for this unit, in this
unit, please use the enclosed thing of a white tape and per-
form line processing.
(The enclosed thing of double sided tape is not used)
• Note: when removing parts
Please remove the clamper and tape of cables beforehand.
• Please do not remove the nonwoven fabric stuck on the
plasma panel for repair of this unit.
1. Remove the S1-Board Block.
(Refer to Removal of S1-Board)
2. Disconnect the connectors (A11, A22).
3. Remove the screws.
36
Advertisement
Table of Contents
