Removal Of Plasma Display Panel - Panasonic TH-50PB2E Service Manual

9. Remove 2 hooks and then remove the 5 Key Button from
V2-Board.
Note: when fixing Glass Holder Bottom(Front) Assy
• Attach the Glass Holder Bottom(Front) Assy after attach-
ing the Power Button Bracket and 5 Key Button.
• Do not damage a lead wire, when you let a lead wire
pass in a notch part of glass .
8.19.3. Removal of Cabinet Assy
1. Remove the Front Glass.
(Refer to Removal of Front Glass)
2. Remove V1-Board and V2-Board.
(Refer to Removal of V1-Board and V2-Board)
3. Remove the LED Panel and Photo IC Receive Panel and
Remote Sensor Panel.
4. Remove the Rear Cover Hook (left, right).
5. Remove the Glass Holder Top(Front) Assy from the Cabi-
net Assy.
8.20. Removal of Plasma Display
Panel
• The C1, C2, C3 Boards are connected with the plasma
display panel for the repair.
• About the enclosed thing for line processing of the
plasma display panel for repair
Although two kinds of enclosed things for line processing are
contained in the plasma display for repair for this unit, in this
unit, please use the enclosed thing of a white tape and per-
form line processing.
(The enclosed thing of double sided tape is not used)
• Note: when removing parts
Please remove the clamper and tape of cables beforehand.
• Please do not remove the nonwoven fabric stuck on the
plasma panel for repair of this unit.
1. Remove the Fan Block (A, B).
(Refer to Removal of Fan)
2. Remove the Slot Block.
(Refer to Removal of Slot Block)
3. Remove the Speaker Block.
(Refer to Removal of Speaker)
4. Remove the Speaker Terminal Block.
(Refer to Removal of H3-Board)
5. Remove SU-Board and SD-Board.
(Refer to Removal of SU-Board and SD-Board)
6. Remove SC-Board.
(Refer to Removal of SC-Board)
7. Remove SS-Board.
(Refer to Removal of SS-Board)
8. Disconnect the connectors (P6, P35).
9. Remove 7 screws ( ).
37
TH-50PB2E