Removal Of A-Board; Removal Of Fan - Panasonic TH-65PB2E Service Manual

Interactive plasma display

Hide thumbs Also See for TH-65PB2E:

Table of Contents

TH-65PB2E

3. Turn over the HX-Board Block.

4. Disconnect the connector (HX1).

5. Remove 2 Hexagonal-Head screws and 2 screws and

then remove HX-Board.

8.5.

Removal of A-Board

The important matter after A-Board exchange

• Since a touch pen setup is come by [OFF] when A-Board is

exchanged, please set to [ON].

1. Remove the HX-Board Block.

(Refer to Removal of HX-Board)

2. Disconnect the connectors (A5, A11, A13, A16, A22,

A27), and remove the flexible cables from the connectors

(A1, A20, A31, A32, A33).

3. Remove the screws and then remove A-Board.

8.6.

1. Remove the Clampers and then remove the Duct Barrier

(SC) Assy and Duct Barrier (SS) Assy.

2. Disconnect the Joint Connectors.

3. Remove the screws and then remove the Fan Block (A),

(B), (C).

4. Remove the screws and then remove the Fans (1, 2, 3, 4)

from the Fan Fixed Metal.

5. Remove the Sponge (Fan Corner) from the Fan.

6. Reassemble the Fans in reverse order.

7. Stick the Fan Sponges around the Fan.

Note:

The Fan Sponge is not re-usable.

Please use a new one when Fan exchange.

Table of Contents