Casio CFX-9800G Owner's Manual page 33

*Specifying 0 sets ihe number of significant digits to-10. Though the display only shows
up.to nine significant digits, 10 are used internally." :
*Note that the number of signification digits setting is cancelled whenever you switch bi
tween the Norm 1 and Norm 2 display formats (see page 60).
The specification for the number of significant digits is applied to the displayed value only.
The calculator still stores the entire 15-digit mantissa and 2-digit exponent of the result
in memory. If you change the number of significant digits specification while a calculation
result is displayed, the display changes to show the result using the new specification.
To specify the display format
SHIFT) (UISP)
3} (Nrm) &2) Norm A
*The display format switches between Norm 1 and Norm 2 each time you perform the
above operation. See page 60 for full details on Norm 1 and Norm 2.
The specification for the display format is applied to the disptayed value only. The calcu-
fator still stores the entire 15-digit mantissa and 2-digit exponent of the result in memory.
If you change the display format specification while a calculation result is displayed, the
display changes to show the result using the new specification.
To specify the Engineering Mode
&
a]
Each time you press (n)QsiFa (Eng) G2), the unit enters or exits the Engineering Mode.
The engineering specification is applied to the displayed value only. The calculator still:
stores the entire 15-digit mantissa and 2-digit exponent of the result in memory. If you
change the engineering specification while a calculation result is displayed, the display
changes to show the result using the new specification.
BLUE
GREEN a
CONTRAS TL
(INIT)
.. Returns tint to default setting.
(2(IN-A)
.- Returns tint and contrast to default setting.
*To adjust the tint
—3)/—