Casio CFX-9800G Owner's Manual page 197

Appendix D Error Message Table
Message ~ Meaning Countermeasure
Syn; ERROR | @Calculation formula contains @use @ or ® to display the
an error. : point where the error was
al @Formula i in a program contains . generated and correct it.
an error. @use @ or ® to display the
point where the error was
generated and then correct the
program.
Ma ERROR | @Calculation result exceeds cal- | OO@@@
culation range. Check the input numeric value
@Calculation i is performed out- and correct it.
side the input range ofa When using memories, check
function, A that the numeric vaiues stored
@lllogical 'operation (division by in memories are correct.
zero, etc.) @try using a smaller value for
@Poor precision in.Z. calculation Ax (x increment/decrement).
" | results. : ®Try using a larger value for 7
a © Poor precision in differential (number of partitions).
. calculation 'results. @Check the coefficients of the
" "\'@ Poor 'précision in integration equation.
calculation results.
@Cannot find results of equation
calculations.:*:'
Go ERROR | @No corresponding Lb! i for @Correctly input a LbI 7 to cor-
Goto n. respond to the Goto x, or
@No program stored in program delete the Goto » if not
area Prog n. required.
@Store a program in program
area Prog n, or delete the
Prog n if not required.
Ne ERROR | | «Nesting of subroutines by Prog | *Ensure that Prog n is not used
n exceeds' 10 levels. to return from subroutines to
main routine. If used, delete
any unnecessary Prog x.
*Trace the subroutine jump des-
tinations and ensure that no
jumps are made back to the
pata original program area. Ensure
f that returns are made correctly.
Stk ERROR Execution of calculations that'
exceed the Capacity of the
'stack for numeric values or
stack for calculations.
*Simplify the formulas to'keep™
stacks within 10 levels for the'
numeric values and 26 levels
for the calculations.
Divide thé formula into two or
more paris.
Mem. ERROR @Specified. expanded value
memory does not exist.
@Not enough memory to expand
value memories specified
number:
@®Not enough memory to input a
function into function memory.
@Not enough memory to create
a matrix using the specified
dimension.
®Not enough memory to hold
matrix calculation result.
®Not enough memory to store
statistical data.
@Not enough memory to input
coefficient for equation.
@Not enough memory to hold
equation calculation result.
@Not enough memory to hold
. function input in the Graph
Mode for graph drawing.
@Not enough memory to hold
function input in the DYNA
Mode for graph drawing.
@Not enough memory to hold
function or recursion input in
the TABLE Mode.
'|®@©OO90O@O0O
Use IER) to correctly expand
the number of value
memories.
eKeep the nuriber of value
memories you use for the
operation within the number
of value memories currently
available.
Simplify the data you are try-
ing to store to keep it within
the available memory ca-
pacity.
Delete no longer needed data
to make room for the new
data.
Arg ERROR
Incorrect argument specification
for a command that requires an
argument.
Correct the argument.
*Sci n, Fix 2: n = integer from 0
through 9.
eLbI x, Goto #: 2 = integer from
0 through 9.
*Prog 7: 2 = 0 through 9, A
through Z, r, @
*Defm a: 2 = integer from 0 up
to the number of remaining
bytes.
Dim ERROR.
*lilegat dimension used during
Check matrix dimension.
matrix calculations.