Viking AES-2000F Technical Practice page 4

B. Surface Mount Chassis (AES-2000S)
The AES-2000S comes with a black powder painted steel surface mount chassis. A knockout is provided on the bot-
tom of the chassis as an alternate wire entrance. The four outer holes on the back of the chassis are for mounting the
box to the wall.
Important: The AES-2000S is rated to operate at temperatures up to 130 degrees Fahrenheit. If the unit is installed
where it is exposed to direct sunlight, the front panel can exceed this maximum temperature. Above this specified max-
imum rating, the buttons will become hot for the tenants to press and the LCD display will go dark.
4.83"
9.66"
Set
Screw
Step 1. To mount the unit to a wall, unlock the panel using the key provided and swing the front panel open.
Step 2. Use the single gang or junction box holes provided in the back of the enclosure for alignment.
Step 3. Fasten the enclosure securely to the wall using the (4) outer chassis mounting holes.
Important: If the enclosure is to be mounted outdoors, use an appropriate sealant between the enclosure and the wall.
Front View of Steel Surface Mount Chassis
Chassis Mounting Holes
Junction Box Holes
0.875" Diameter
Knockout
4.
6.13"
4.5"
0.875" Diameter
Knockout
AES-2000
(3) Hinge Holes
Single Gang Box Holes
12.26"
9.0"
1.5"
3.0"
(4) 0.16" Diameter
Typical
* Note: To help steer visually impaired visitors to the location
* Optional Braille
of the EZ™ HELP button, the optional Braille "Audio" label
"Audio" label (included)
may be adhered above the push button.
AUDIO
Hinge
(2) 0.20" x 0.43"
Slots Typical
3.0"
1.65"
1.5"
3.0" 3.3"
6.0"
(4) 0.26" Diameter
Typical
Steel Surface Mount
Chassis (included)
(3) Screws (included) for
mounting the AES-2000 to the
surface mount chassis.
4.0"
4.0"
Use Sealant