Table of Contents
Advertisement
I
n
s
t
a
l
l
a
t
i
o
I
n
s
t
a
l
l
a
t
i
o
A. Flush Mount Chassis (AES-2000F)
The AES-2000F comes with a zinc-plated steel rough-in box and a black powder-painted steel mounting ring. The
rough-in box is meant to be framed into the wall. Make sure the outer edge of the box is within 1/4 inch of the finished
surface of the wall, but not protruding past the surface level. Knockouts are provided in the box to accommodate con-
duit entrance from the sides or bottom.
Important: The AES-2000F is rated to operate at temperatures up to 130 degrees Fahrenheit. If the unit is installed
where it is exposed to direct sunlight, the front panel can exceed this maximum temperature. Above this specified max-
imum rating, the buttons will become hot for the tenants to press and the LCD display will go dark.
9.75"
1.26"
Step 1. After the wall is finished, the mounting ring can be screwed to the rough-in box.
Step 2. Once the mounting ring is secure, the front panel of the AES-2000S can be fastened to the ring using the 3 screws and
nuts provided by aligning the hinge with the three holes on the right side of the frame.
Note: Make sure the key lock is in the open position.
Step 3. Insert the screws and tighten the nuts firmly.
Note: Be careful not to damage the foam gasket around the back edge of the panel.
* Optional Braille
"Audio" label
(included)
AUDIO
AES-2000
Important: If the enclosure is to be mounted outdoors, use an appropriate sealant around the outer edge of the mounting ring.
* Note: To help steer visually impaired visitors to the location of the EZ™ HELP button, the optional Braille "Audio" label may be
adhered above the push button.
n
n
Front View of Steel Rough-In Box
12.25"
9.74"
4.87"
0.875" Diameter Knockout
Mounting Ring
(included)
Hinge
(3) Screws (included) for mounting
the AES-2000 to the ring
1.25"
0.875" Diameter
Knockout
Right Side View (same as
(8) 0.187"
Left Side minus Knockout)
Diameter Holes
1.25"
Bottom View (same as Top
2.5"
View minus Knockout)
0.45"
Steel Rough-In Box
(included)
Sealant
0.45"
1.25"
3.625"
7.25"
The rough-in box
should be framed
into the wall.
0.875" Diameter
Knockout
(8) Screws (included) for mounting
the ring to the rough-in box.
3.
Advertisement
Table of Contents
