Advertisement
Specifications
AUDIO section
Rated power output (FRONT)
f
80 watts
per channel
minimum
RMS,
both
channels
driven, at 8 ohms, from 20 Hz to 20 kHz with no more
than 0.08% total harmonic distortion.
Rated power output (REAR)
18 watts
per channel
minimum
RMS,
both
channels
driven, at 8 ohms at 1 kHz with no more than 0.9% total
harmonic distortion.
Dynamic power
Per channel at 4 0) ooo
cece eesetsctsestesenseneee 237 W
Per channel at 8 Qo...
ce ceecece secs ecenenseeeee 146 W
Total harmonic distortion
Rated output power at 8 ,
20:H2-20.000 Hid: .....ceececee.
dl eeteded lees abcee adits 0.08%
Rated output power at 8 1,
TAZ
cee
heen eee
ae
Hlaon teen
and Meee
0.02%
Frequency response
PHONO
RIAA MM
.........
20 Hz ~ 20 kHz, +0.3 dB
CD, TUNER, TAPE
...........000..... 5 Hz ~
100 kHz +0, —3dB
For the U.S.A.
Signal to noise ratio
PHONO
(MM)
LW.
78 dB (IHF '66) 79 dB (IHF '78)
CD, TUNER, TAPE ............ 100 dB (IHF '66) 84 dB (IHF '78)
Tone control
BASS
oie ccek Rivenenetite
esses hislalvsdviastise +10
dB (at 100 Hz)
Wreble: casi
iia Ain
ies Baas +10 dB (at 10 kHz)
Damping factor
0... ccc
ccecc ete eteeneeee 40 (50 Hz at 8 0)
Input sensitivity/impedance
PHONO
(MM) ...000.0.o
cc
ccencerereerereeeeee 2.5 mV, 47 kD
CD, TUNER, TAPE
uuu. ee 150 mV, 47 kQ
PHONO
maximum
input level
(PHONO
to TAPE
REC)
MM at 1 kHz, 0.05%
SAL Doh
teen
es
kth
els eae
A eet tae aateet te to Maint 145 mV
Video section
Television format oo...
ccc ccceecetsscsesscseeccsceesseeaecsees NTSC
Rated input eo6.56 ho
eee
ek
ae
1 Vp-p, 75 2
Rated output
0...
cece
eeeeeeetcseeeeeneeee 1 Vp-p, 75 Oo
General
;
Power consumption
.......0.0..0.0.00cc 3.3 A (USA & Canada)
340 W (other countries)
DiMeNnsiIONS 0.0.0...
ec ce ccc cece eee reeeee W: 440 mm
(17-3/8")
H: 163 mm (6-7/16")
D: 428 mm (16-7/8")
Weight (Net) 0.00.0.
ceereerereees 15.0 kg (33 Ib)
Note:
—
—@ A
SSS
KENWOOD
follows
a policy
of continous
advancements
in
development.
For this reason
specifications
may
be changed
without notice.
FCC WARNING:
Note:
following measures:
® Reorient or relocate the receiving antenna.
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause
harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the
authority to operate this equipment if an unauthorized change or modification is made.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment may cause harmful interference to radio communications, if it is not installed and used in
accordance
with the instructions.
However,
there is no guarantee
that interference
will not occur
in a particular
installation. lf this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
® Increase the separation between the equipment and receiver.
® Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
® Consult the dealer or an experienced radio/TV technician for help.
36 = KA.v6000 (En)
Advertisement
