Advertisement
LEARN
TRANSMIT
©
©
Fe Tu
Set to USE.
Remote
control unit
entry sheet
Reset key
Notes:
M@ To check
the programmed
(stored) con-
tents
1. Verify that the LEARN/USE switch is set to USE.
2. Press the key you want to check the function of.
3. Check to see if the intended function is activated.
M@ To change the programmed
(stored) con-
tents
Re-start
the
programming
operation.
The
previously-
programmed
contents are cleared automatically and re-
placed by the newly-programmed
contents.
# To perform normal remote control opera-
tion
. Set the LEARN/USE switch to USE.
2. Press
the
"learning"
key under
which
the
required
function signal has been programmed. The TRANSMIT
indicator
lights and
the
remote
control
function
is
performed.
=
@ Remote control unit entry sheet
It is recommended to write the programmed functions on
the supplied remote control unit entry sheet.
Use an oil-ink felt pen or pencil. To erase, rub strongly with
an ordinary eraser.
™@ To clear the whole
of the programmed
(saved) contents
The contents
of all "learning"
keys programmed
in all
modes (both audio and visual) can be cleared at once.
1. Set the LEARN/USE switch to LEARN.
2. Press one of the "learning" keys.
®@ The LEARN
indicator lights up.
3. Remove
the battery
case
cover
on
the
rear
of the
remote control unit.
4. Press the Reset
key inside the battery case
with a
ball-point pen tip, etc.,
@ All
of
the
previously-programmed
contents
are
cleared simultaneously, and the remote control unit Is
reset to the initial condition.
Almost
all of the remote
control
systems
used
with
other AV components use the same infrared system as
this
unit.
This
means
that
this
unit
is capable
of
programming
the
functions
of
almost
all
remote-
controllable components.
Before programming,
please
read
carefully
the
instruction
manuals
of other
AV
components as well as this Instruction Manual.
1. If the optical output power of the other remote control unit is
too large, programming
could fail. In such a case, place the
remote
control unit at a greater distance from this remote
control unit.
2. \f both the LEARN
indicator and TRANSMIT
indicator blink
simultaneously, either the key is not a "learning" key which
can be used for programming or the current programming is
incomplete. In' such cases, program the function again under
a "learning" key.
3. Programming
is also impossible
if the other remote
control
unit uses a signal format other than the infrared system, if it
uses
a special
signal modulation
format,
or if the storage
capacity of this unit has become full.
4. 30 seconds
after a "learning"
key is pressed,
the LEARN
indicator goes from on to off (extinguished). As programming
is impossible while the indicator is off, press the "learning"
key again to light the indicator.
5. If more than one "learning" key is pressed, the function signal
is programmed
under the last pressed key.
6. Never attempt to program (store) the remote control functions
of appliances other than A/V components, such as air condi-
tioners.
KA-V6000 (En)
19
Advertisement
